A covered bond cover pool is the ring-fenced set of assets that secures a bank's covered bonds. It usually consists of residential or commercial mortgage loans or loans to public sector bodies, together with limited amounts of substitute assets and hedging derivatives. Bondholders have a claim on the issuing bank and, if the bank fails, a preferential claim on the pool, an arrangement known as the dual recourse mechanism.
The pool stays on the issuer's balance sheet, unlike the assets in a securitisation, and the issuer must keep it at a level that covers the bonds with a margin of overcollateralisation. In the European Union, the rules for cover pools are set by the Covered Bond Directive, Directive (EU) 2019/2162, and by Article 129 of the Capital Requirements Regulation, which adds conditions for preferential capital treatment. National covered bond laws, such as the German Pfandbrief Act, implement and add to these rules.
What a cover pool contains
Most cover pools belong to one of two families. Mortgage pools hold mortgage cover assets, residential or commercial loans secured on property and eligible only up to a set share of the property's value. Public sector pools hold public sector cover assets, such as loans to governments and regional or local authorities, or loans guaranteed by them. A few countries also allow pools of ship loans, though these are small.
Alongside the primary assets, laws generally allow three further kinds of holding:
- Substitute assets. High-quality exposures, such as government bonds or deposits with strong banks, which may be added within limits to replace repaid loans or to hold cash for a time.
- Liquid assets. Assets held for the covered bond liquidity buffer, which in the EU must cover net liquidity outflows over the next 180 days.
- Derivatives. Interest rate and currency swaps used only to hedge mismatches between the pool and the bonds, registered as part of the pool so that the swap counterparties rank alongside bondholders.
Eligibility and valuation
Each asset must satisfy rules on type, location, documentation and quality. For mortgages, the central test is the loan-to-value ratio. Under the amended Capital Requirements Regulation, a residential loan counts toward coverage only up to 80% of the property's value and a commercial loan generally up to 60%; any excess may stay in the pool but adds nothing to coverage. Property values are set by an independent valuer at origination and then monitored, often by indexation to house prices, so that falling prices reduce the eligible amount. Loans that default or fall into serious arrears are usually excluded from the coverage calculation and replaced with new eligible loans.
Coverage and overcollateralisation
The asset coverage requirement obliges the issuer to hold cover assets at least equal to the liabilities of the bonds, including interest and the expected costs of winding up the programme. The Directive allows this to be calculated on a nominal basis or on an equivalent net present value basis. For bonds that receive preferential treatment under the Capital Requirements Regulation, the pool must also hold at least 5% overcollateralisation, which member states may lower to no less than 2% under certain conditions.
A simple measure of the margin is the overcollateralisation ratio:
Here eligible cover assets are measured after any loan-to-value cap, and both amounts are usually taken at nominal value. For example, if a pool holds 11.5 billion euros of eligible assets against 10 billion euros of bonds, , or 15%. Issuers often keep voluntary or contractually committed overcollateralisation well above the legal minimum to support their credit rating. Compliance is checked through cover pool maintenance tests, usually at least monthly.
Segregation and the issuer's insolvency
The pool's value to investors depends on cover pool segregation. Under statutory models, assets entered in a cover pool register are separated by law from the issuer's estate if it becomes insolvent. Under structured models, used historically in the UK and some other countries, the assets are transferred to a separate entity that guarantees the bonds. Either way, the pool must be protected from claims by the issuer's other creditors and must be able to keep paying the bonds on schedule. A special administrator or the guarantor then manages the pool, and maturity extension features such as a soft bullet maturity give it time to collect cash rather than sell assets at a discount.
Monitoring and disclosure
Supervision of the pool has several layers. A national authority supervises covered bond issuers, and many laws require an independent cover pool monitor to check eligibility and coverage. Under the Directive the issuer publishes covered bond investor reporting at least quarterly, and labelled issuers use the Harmonised Transparency Template so that pools can be compared across countries. Rating agencies monitor the credit quality of the pool and the level of overcollateralisation each rating requires. The assets committed to the pool also count as encumbered on the bank's balance sheet, which supervisors track through asset encumbrance monitoring because heavy encumbrance leaves less for unsecured creditors and depositors.